[AGENT++] About V3 Inform

[Frank Fock]

Hi Santosh,

I would assume that it is a USM configuration problem.
With informs the inform receiver is the authoritative
engine. That is different to sending traps.
Why it works with SNMP++ could be caused by the engine ID
and/or USM configuration being accidentally the same
as at the agent.

Best regards,
Frank

Santosh Akhilesh wrote:
> Dear All ,
> 
> I have a SNMP Agent using Agent++ 3.5.26 and SNMP++ 3.2.20.
> 
> If my agent sends V3 Informs it is not received by MG Soft MIB browser but
> it is received if I write a Inform Listener using SNMP++.
> 
> Did anyone face such problem and if yes what is the reason and possible
> solution.
> 
> Regards,
> 
> Santosh Akhilesh
> 
> Ph: 9845482201
> 
> ****************************************************************************
> **************
> 
>  This email and its attachments contain confidential information from
> HUAWEI, which is intended only for the person or entity whose address is
> listed above. Any use of the information contained herein in any way
> (including, but not limited to, total or partial disclosure, reproduction,
> or dissemination) by persons other than the intended recipient(s) is
> prohibited. If you receive this e-mail in error, please notify the sender by
> phone or email immediately and delete it!
> 
>  
> ****************************************************************************
> *************
> 
>  
> 
> _______________________________________________
> AGENTPP mailing list
> AGENTPP at agentpp.org
> http://lists.agentpp.org/mailman/listinfo/agentpp

-- 
AGENT++
http://www.agentpp.com
http://www.mibexplorer.com
http://www.mibdesigner.com